User's Manual
Table Of Contents
- UA-612 Installation Sheet V1.2
- Reader Description
- Parts List
- Installation Procedure
- Product Specifications
- Cable to Controller and Power Supply
- Reading Distance
- Notes
- 1. Connect the black wire (negative) first, and the red wire (positive) last. Disconnect power before any wiring changes.
- 2. The LED and Beeper lines are logic levels. Never apply power to them. They may be pulled to a low level (0 to 1.2 VDC) to enable their functions, and left floating or pulled to a high level (3.6 to 5.0 VDC) when not used.
- 3. UA-612 readers have both Wiegand-protocol and RS-232 serial interfaces. For information on RS-232, contact AWID’s technical support.
- 4. For additional information, please visit AWID’s Web site www.awid.com. For technical support questions visit www.awid.com/support or call 1-800-369-5533 (in the U.S.) or 1-408-825-1100 from 8:00 a.m. to 5:00 p.m. Pacific Time.
- 5. FCC Compliance: This equipment has been tested and found to be in compliance with the limits for FCC part 15, Class A digital device. These limits are designed to provide reasonable protection against harmful interference when the equipment is operated in a commercial environment. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with instruction manual, may cause harmful interference with radio communications. Operation of this equipment in a residential area is likely to cause harmful interference in which case the user will be required to correct the interference at his own expense.
- The users are prohibited from making any change or modification to this product. Any modification to this product shall void the user’s authority to operate under FCC Part 15 Subpart A Section 15.21 regulations.
- This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.
- UserManual
MPR-2010-2.7E4-CN Page 10 7/22/2008
BR or BN
Power up PC
Install demo software on PC
Activate demo software and verify performance of the reader.
Select a COM port for BR or type in the IP address for BN on top page then click
“Connect”. Follow with some commands.
Place the RFID tags at the exact same locations as the final configuration
Measure tag’s read distance and confirm that read distance is correct.
LR-911
Connect the SP-6820-LR test unit, which is part of the LR Installation Kit, to the
Reader cable. Use the wiring list in the Installation Instructions. Apply power to
the reader and the test unit, using the plug-in DC power module in the Installation
Kit.
Use either a Prox-Linc WS tag that is attached firmly by its adhesive to a
rectangle of windshield glass, or a Prox-Linc MT tag for verification. Hold the tag
so that the hand does not interfere with direct line-of-sight between the tag and
the Reader.
Move the tag into the field. Observing the SR-6820-LR test unit, there is a brief
LED color change and a beep to indicate each read of the tag by the Reader.
Reads will repeat at a rate that is determined by the Reader’s firmware.
Move the tag from side to side, and at varying distances from the front of the
Reader housing, to determine the space in which the tag and Reader are active.
4.2.2 Aiming of Antenna
Antenna Pattern
MPR-2010-2.7E4-CN reader comes with a circular polarized antenna to ensure reading
tag with random orientation. Most circular polarized antenna has a horizontal to vertical
differential of up to 3 dB, this will cause the antenna pattern to deviate from a true circle.
AWID’s antenna has a horizontal to vertical differential of typically less than 0.5 dB,
making its pattern as near to a circle as possible.