User's Manual
Table Of Contents
- Reader Description
- Parts List (a) Installation Sheet 1
- Installation Procedure
- Operation Modes NDK-2025 Reader supports the following operation modes of the host system:
- 1. Power down before any wiring changes. Connect the black wire (ground) first, and the red wire (power) last.
- 2. When the brown and yellow wires are not used, the LED and beeper remain active, under the reader’s internal control.
- 3. The LED, Beeper and Hold lines are logic levels. Never apply power to them. They may be pulled to the low logic level (0 to 1.2V DC) to enable their function, and float at the high logic level (3.6 to 5.0V DC) when not used.
- 4. The NDK-2025 card reader has both Wiegand-protocol and RS-232 serial interfaces. The NDK-2025 keypad has only 26-bit Wiegand output on the same 2 data lines.
- 5. For additional information, please visit AWID’s Web site www.awid.com. For technical support questions visit www.awid.com/support or call 1-800-369-5533 (in the U.S.) or +1-408-825-1100 from 8:00 a.m. to 5:00 p.m. PST.
- 6. FCC Compliance: This equipment has been tested and found to be in compliance with the limits for FCC part 15, Class A digital device. These limits are designed to provide reasonable protection against harmful interference when the equipment is operated in a commercial environment. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with instruction manual, may cause harmful interference with radio communications. Operation of this equipment in a residential area is likely to cause harmful interference in which case the user will be required to correct the interference at his own expense.
- The users are prohibited from making any change or modification to this product. Any modification to this product shall void the user’s authority to operate under FCC Part 15 Subpart A Section 15.21 regulations.
- This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.
- 7. Industry Canada Compliance: Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference, including interference that may cause undesired operation of the device.
Installation Sheet (Wiegand Interface)
NDK-2025 Reader with Integrated Keypad
NDK-2025 Reader with Integrated Keypad V1.1 Page 3 of 4
FCC Radiation Exposure Statement
This equipment complies with FCC radiation exposure limits set forth for an
uncontrolled environment . End users must follow the specific operating
instructions for satisfying RF exposure compliance. To maintain compliance with
FCC RF exposure compliance requirements, please follow operation instruction as
documented in this manual.