User's Manual

5.2 Installation Steps

a. Position the Reader at the appropriate mounting position.

b. Drill four 7/64 (0.109)-inch holes as shown on the installation instruction.

c. For mounding surface smaller than 8X8 inches: remove the top cover and drill

appropriate mounting holes on the base plate of MR-1824.

d. Drill one clearance hole for the cable and wiring lug.

e. Guide the open end of the Panel’s control cable through the clearance hole.

f. Connect the Reader and the Panel together according to Figure 5.2-1 for Wiegand format

and Figure 5.2-2 for RS-232 and Figure 5.2-3 for Wiegand/RS-232 format.

5.3 Verification

a. Power up the PANEL, the LED on the Reader should show RED.

b. Place a “good” card in front of the Reader and keep it in that position. The reader will

give out “ONE” audible BEEP and the LED will change from RED to AMBER momentarily

and than flashing between RED & GREEN. The reader will stay flashing until the panel

sends an acknowledgement or until the card is removed from the reader. You can repeat

this action by placing the card in front of the reader after the LED turned RED.

c. The reader uses an internal micro-controller to manage its many functions, and the

micro-controller must be initialized properly. When the reader show evidence of mail

functioning, turn off the reader and wait for five seconds before energize the reader

again.

Fig. 5.2-1 Wring Diagram for Wiegand Output Format

Fig. 5.2-2 Wiring Diagram For RS-232 Output Format

AWID PROPRIETARY