User's Manual

When troubleshooting, try to identify the source of the problem to a unit level. “Is the problem

from the panel?” Or “is the problem originated from the Reader? “ Maybe the problem “is the

power supply?”

All AWID’s readers will need only a power supply and a valid card to work properly. If the

reader is only connected with RED (+5-12V) and BLACK (Ground), the reader will BEEP and

momentarily turned AMBER, when a valid card is presented. If the Card stays within the reader

zone of surveillance, the LED on the reader will become flashing GREEN. When the card is

removed, the LED will return to RED, signifying it has returned to stand-by mode. When the

reader works according to the tests above, the reader is working properly.

Do not cycle the power supply ON and OFF in rapid succession. Each power has its unique

“decay” characteristics, turning the power supply ON and OFF in rapid succession can cause

the Microcontroller to lock-up, due to improper initialization. Always turn the power supply OFF

and count 10 seconds before turning ON again.

To check the validity of the output data in the absence of a panel, you will need to build a patch

cable between the reader and a PC. Call AWID’s technical support for details.

If problem persists, consult the system manufacturer. If problem is the reader, consult AWID’s

Technical Assistance Department. AWID help desk is opened from 8:00 AM to 8:00 PM

Eastern Standard Time, and can be reached by dialing 1-800-369-5533.

9.0 PATENTS AND APPROVALS

AWID products are covered by United States patent #5594384.

AWID logo is a registered trademark of Applied Wireless Identifications Group, Inc.

Where required, AWID’s products will be approved by the appropriate regulatory agencies:

U. S. Federal Communications Commission: Part 15

Underwriter Laboratory: UL 294

Designed to Comply with: CE, UL, VDE, BZT, DTI & PTT

Information To The User

This device complies with part 15 of the FCC Rules. Operation is subject to the following two

conditions: (1) this device may not cause harmful interference, and (2) this device must accept

any interference received, including interference that may cause undesired operation.

AWID PROPRIETARY