User's Manual

Table Of Contents

MPR-1910 - 2 - 9/21/2009

The contents of this document are the property of Applied Wireless Identifications Group, Inc.

strictly prohibited. For additional copies of this document please contact:

AWID

18300 Sutter Blvd

Morgan Hill, CA 95037

http://www.AWID.com

The information contained herein has been carefully checked and is believed to be accurate,

no responsibility is assumed for inaccuracies. AWID reserves the right to make changes

without prior notice. This document is not covered by any warranty either expressed or

implied. Any comments, corrections or additions to the contents of this document should be

directed to AWID at the above address.

All other trademarks are the property of their respective owners.

FCC COMPLIANCE

You are cautioned that changes or modifications not expressively approved by the party

responsible for compliance could void you authority to operate the equipment.

FCC RF Radiation Exposure Statement:

1. This Transmitter must not be co-located or operating in conjunction with any other antenna

transmitter.

2. This equipment complies with FCC RF radiation exposure limits set forth for an uncontrolled

environment. This equipment should be installed and operated with a minimum distance of 20

centimeters between the radiator and your body.

Information for OEM integrator:

The OEM integrator has to be aware not to provide information to the end user regarding how

to install or remove this RF module in the user manual of the end product. The user manual

which is provided by OEM integrators for end users must include the following information in a

prominent location.

“To comply with FCC RF exposure compliance requirements, the antenna used for this

transmitter must be installed to provide a separation distance of at least 20 cm from all persons

and must not be co-located or operating in conjunction with any other antenna or transmitter. If

the end product integrating this module is going to be operated in 5.15 ~5.25GHz frequency

range, the warning statement in the user manual of the end product should include the

restriction of operating this device in indoor could void the user’s authority to operate the

equipment.”

Label for end product must include “Contains FCC ID: OGSMPR1910” or “A RF

transmitter inside, FCC ID: OGSMPR1910”.

The user is cautioned that this device should be used only as specified within this manual to

meet RF exposure requirements. Use of this device in a manner inconsistent with this manual

could lead to excessive RF exposure conditions.