User's Manual

ii
This device and its antenna(s) must not be co-located or operating in conjunction with any other
antenna or transmitter.
RoHS Statement
This device conforms to RoHS (Reduction Of Hazardous Substances) European Union
regulations that set maximum concentration limits on hazardous materials used in electrical and
electronic equipment.
Laser Information
The AWID HH-6600 series is certied in the U.S. to conform to the requirements of DHHS/CDRH
21CFR Subchapter J and to the requirements of IEC 825-1. Class II and Class 2 products are
not considered to be hazardous. The HH-6600 series contains internally a Visible Laser Diode
(VLD) whose emissions do not exceed the maximum limits as set forth in the above regulations.
The scanner is designed so that there is no human access to harmful laser light during normal
operation, user maintenance or during prescribed service operations.
The laser safety warning label required by the DHHS/IEC for the HH-6600 series’s optional laser
scanner module is located on the memory compartment cover, on the back of the unit.
CAUTION!
Use of controls or adjustments or performance of procedures other than those
specified herein may result in hazardous laser light. Use of optical instruments
with the scanner will increase eye hazard. Optical instruments include binoculars,
microscopes, and magnifying glasses. This does not include eye glasses worn by
the user.
Notices
This unit is equipped with battery packs and backup battery. It is possible that the AWID HH-
6600 may not power-on due to battery discharge as a result of storage.
In the above situation, plug the HH-6600 to the USB charging cable which is with DC in port or
put the unit into the AWID HH-6600 Cradle (with 12V/2A AC-DC adapter), and recharge the unit
for 16 hours in order to fully charge its backup battery.
The backup battery will charge from external power or the main battery (if the main battery still
has enough power to turn on). In the event the main battery is fully charged, refrain from using
the HH-6600 for 16 hours in order for the main battery to fully charge the backup battery.
Backing-up data by backup battery only without the main battery installed in battery compartment
may take as long as 6 hours. Therefore, in order to prevent data protection failure due to backup
battery failure, do not leave the HH-6600 without the rechargeable battery pack installed, or
without connection to AC power for an extended period of time.
NOTE:
The rst time you use the HH-6600, you must turn on the backup battery switch. ● See turn on
the backup battery & grip battery switch on page 6 for more information.