Technical Manual

APPLIED TECHNOLOGY SOLUTIONS, INC.
Document: FCC1225manual.wpd issued: jan99 revised: July 27, 1999 page: 3
1.2 CONTROLS, INDICATORS, USER I/O
This section describes the user interfaces and indicators provided by the Model 1225 Hand Held
Transceiver.
USER CONTROLS
VOLUME Dual function rotary switch. It is the power on/off switch plus volume control
CHAN The channels are A, B and R where R refers to repeater operation.
CODE A two position switch allowing selection of either the common (C) or private (P) code.
PTT A momentary push button switch that places the Model 1225 in the transmit mode.
STATUS INDICATORS
PWR Green, multi-function LED. Steady illumination indicates that power is on and battery condition
is normal. Blinking LED indicates that the battery voltage is low and approximately 180
minutes of receive or 15 minutes of transmit operation remain from the time the light starts
blinking.
TX Red LED, when illuminated, indicates that unit is in transmit mode.
USER CONNECTIONS
Key Loader A rear panel connector accessed by sliding the door. Connecting the Model 1260 Key Loader
to this port, privacy codes can be downloaded from the loading device to the Model 1225 where
they are stored in non-volatile memory. Operating power for the Model 1260 is supplied from
this connector.
Mic Side panel, 4 pin microphone connector. Accepts the standard Model 1230-04 Surveillance
Micphone/Earpiece Assembly.
CONNECTOR SPECIFICATIONS
Microphone: Hirose HR10A-7P-4P
Antenna: SMA Female to mate with special panel mount connector
NOTE: only the ATS provided antenna should be used with the Model 1225
Key Loader: ATS Model 1230-03 Adapter Cable