User Guide

Selectronic Premier (with 1.25m hose)
Selectronic Premier Plus (with 2m hose)
23
Ensure the electricity is switched ON to the unit at both the
Mains Power Board and isolating switch.
27
29
Press and hold the Cooler button until
confirmed with one audible short bleep.
The digital display will illuminate
with a capital “C”.
30
Allow the unit to fill. Wait for water to
come out of handset. Press Stop/Start
button turning the shower OFF
(Confirm with 3 audible short bleeps).
28
Ensure that all the retaining screws are
VERY tight and that no cable insulation is
trapped under the screws. Replace the
inlet cover and side access trimplate
section complete with seal.
IMPORTANT Connect flying lead
from PCB to rear of the front cover.
24
25
Replace the front cover and fasten in
position with four screws.
Ensure the water is switched
ON to the unit.
26
16