User Guide

All measurements shown are in millimetres. Drawing sizes are not to scale. Shower model shown is a Selectronic Premier Plus.
15
The Inlet fitting is designed to rotate
through 180° to allow for either
Top or Bottom/Rear entry fitting.
Plumbing - Top Entry Option.
19
A means for disconnection in all poles
must be incorporated in the fixed wiring
in accordance with the wiring rules.
Either wall mounted or ceiling switches.
20
Electrical - Bottom Entry Option.
21
Electrical - Top Entry Option.
22
Electrical - Rear Entry Option.
16
Plumbing - Rear Entry Option.
17
Turn ON the mains water supply and
check for leaks in the pipework
connection to the shower. Note: At this
stage no water can flow through the unit.
18
Turn OFF the electricity at the
Mains Power Board.
Remove side access trimplate
section complete with seal.
Turn off the water supply at
the mains stop valve.
Note: We recommended that a WRAS
listed isolating valve be fitted between
the rising main and the unit for any future
service needs without having to turn off
the house water at the stop valve.
Connect the mains water supply to the
Inlet of the shower via 15mm copper,
stainless steel or plastic pipe using a
15mm compression fitting.
Plumbing - Bottom Entry Option.
11 12 13 14
Typical guideline dimensions used for less-abled bathroom installations.
15