User Guide

For the User
Symptom
Little or no water flows The main water supply is turned off. Turn on the main supply fully at the
stop valve.
Cold water only
- neon light off.
The main water supply is not
turned on enough.
The filter is blocked or the brass jet is
wrongly positioned
Turn on the main supply fully at the
stop valve.
Clean and reassemble the filter as
described on page 9.
Water too cold
- neon light on.
The water flow rate is too high.
The inlet water temperature
has dropped.
Adjust the service valve (see page 7).
Adjust the service valve (see page 7).
For a shower, adjust the spray pattern
available on the multi-mode handset.
Water flow too
low, or temperature
too high
The main supply water flow is too
low.
The hot tap is not fully open.
Increase the supply water flow. Make
sure that the service valve is correctly
adjusted.
Adjust the service valve so that the
water is at the right temperature with the
tap fully open (see page 7).
Always turn the hot tap full on.
Water goes from
hot to cold
The water flow or pressure is too
low, and the thermal cut-out is
operating.
The filter is blocked.
A second outlet has been turned on.
Increase the supply water flow.
Make sure that the service valve is
correctly adjusted.
Clean it (see page 9).
Do not use the basin while using the
shower.
Shower spray pattern
deteriorates
If the problem persists
The person who initially installed the unit is probably the best one to contact for help.
You can also call Redring’s Technical Advisory Hotline on 01733 456999.
Please have this guide with you when you call.
For non UK customers please contact your local distributor.
The shower handset is clogged. Clean the handset - using descaling
solution if required (see pages 7&8).
Cause What to do