IMPORTANT: This booklet should be given to the customer after installation and demonstration.
Fixing to the wall ● Undo the retaining nuts and take the front cover off the unit. Hold the backplate in position against the wall while you mark the four fixing holes. ● Drill the holes and fix the unit to the wall using the four No 8 x 38mm wood screws supplied. Plumbing the unit Warning - Do not use a non-return valve in the inlet feed to the unit. - Do not fit the unit within 2 metres of a stop valve. Fitting the pipes ● The unit should be connected directly to the main cold water supply.
finish and Diagram 6: ● Service valve supplied with: UK Models ● ● Service valve supplied with: Export Models : 6
cubicle or bath. The installation should be supervised by a qualified electrician. For further details, including a comprehensive list of accessories and spares for all Redring products, contact your local dealer, or call Redring's sales office on 01733 456700. For non UK customers please contact your local distributor.
If you have any queries See page 10, then call the Redring Technical Advisory Hotline on 01733 456999. For non UK customers please contact your local distributor. If you need further information, we will be glad to help you with any installation enquiries. - IMPORTANT Demonstrate the unit to the user and give them this guide.
Flow rate (litres/min) Summer temp oC 3.0 4.0 6.0 - 54o 43o 39 o 28o Winter temp C 50 Flow rate (litres/min) 4.0 5.0 6.0 - 51o 46o 36 o 31o o Summer temp oC o Winter temp C 44 Flow rate (litres/min) 5.0 6.0 7.
For the Installer Symptom Cause Little or no water flows - The water pressure is very low. neon light off. Cold water only - neon light off. Water too cold - neon light on. What to do Use a pump to boost the supply from a storage tank. The filter is blocked or there is dirt in the unit. Disconnect the unit and flush it through. Clean the filter as described on page 9. The main water supply is connected to the OUTLET of the unit. Reconnect the main supply to the INLET (marked in blue).
For the User Symptom Cause What to do Little or no water flows The main water supply is turned off. Turn on the main supply fully at the stop valve. Cold water only - neon light off. The main water supply is not turned on enough. Turn on the main supply fully at the stop valve. The filter is blocked or the brass jet is wrongly positioned Clean and reassemble the filter as described on page 9. The water flow rate is too high. Adjust the service valve (see page 7).
Guarantee We, Applied Energy Products Ltd., guarantee that should this Powerstream unit prove to be defective by reason of faulty workmanship or material within 36 months (outside the UK, please contact your local distributor) of the date of purchase or commencement of hire we will replace the defective parts FREE OF CHARGE on condition that: a) The appliance has been correctly installed and used only on the supply circuit or voltage stamped on the rating plate.
