User Guide

PLUMBING CONNECTIONS .
• The Chrome Monoblock Mixer Tap is supplied with three 8mm diameter annealed copper pipes attached.
Note: - The assembly is chromium plated.
• Connection to the WS7 water heater will be made by use of 15mm copper pipe.
• It is recommended that 8mm – 15mm compression adapters are used.
Alternatively 8mm – 15mm soldered adapter may be used.
Note: - If soldered adapters are selected it is recommended that the chromium finish is removed at the point
where the solder joint is made. The use of flexible pipe or convoluted copper pipe is also recommend.
Inlet Cold Water
• This is connected to the Chrome Monoblock Mixer Tap and not to the water heater.
• Connection is made to the pipe marked with a blue arrow which points up towards the mixer block.
Outlet Cold Water
• Connection is made from the pipe of the mixer block which is marked with a blue arrow which points
down away from the mixer. The pipe is connected to the water heater cold water inlet. WHICH IS MARKED
BLUE.
INLET HOT WATER .
• This is connected from the water heater hot outlet WHICH IS MARKED RED to the pipe going to the mixer
block, which is marked with a red arrow pointing towards the mixer.
WARNING: DO NOT SWITCH ON THE WATER HEATER AT THIS STAGE.
• Turn the temperature regulation knob (marked with a red and a blue arrow) fully in the direction of the red
arrow.
• Turn the other knob fully anti-clockwise. This will allow water to flow into the water heater.
Only when the water heater is full will the water flow out of the heater and out of the mixer tap spout.
• It is possible that air will be expelled in spurts when the water heater is first commissioned. Switch on the
electricity supply to the water heater ONLY AFTER A STEADY STREAM OF WATER IS SEEN ISSUING
FROM THE SPOUT OF THE MIXER TAP.
OPERATING THE CHROME MONOBLOCK MIXER TAP .
There are two knobs on the mixer tap. The knob marked with a red and blue arrow regulates the water
temperature. The other knob allows cold water to flow into the water heater. This displaces the stored hot water,
which flows out from the mixer spout.
NOTE: As the water heats in the water heater it expands. This will cause a few drips to be visible at the mixer
spout during the heating process. This is quite normal and not a fault.
NOTE: The efficiency of the water heater will be impaired if the tubular plastic pressure regulator is not installed in
line with the table detailed.
GUARANTEE .
We, Applied Energy Products Limited, guarantee that should this appliance prove to be defective by reason of
faulty workmanship or material within 12 months of the date of purchase or commencement of hire, we will
replace the defective parts FREE OF CHARGE on the condition that:-
• The appliance has been correctly installed.
• The appliance has been used in accordance with these instructions and has not been tampered with or
other wise subject to misuse, neglect or accident.
• The appliance has not been taken apart, modified or repaired except by an authorised person.
• Evidence of the date of purchase in the form of an invoice, receipt (hire purchase documents) is included with
the appliance of returned under guarantee.
This guarantee does not affect your statuary rights.
Full details of terms and conditions of guarantee are available on request from:-
APPLIED ENERGY PRODUCTS LIMITED
MORLEY WAY, PETERBOROUGH PE2 9JJ
TEL [phone] / FAX: [phone]
Website: www.redring.co.uk
(Leaflet No:- 578-2137-01A)