Technical data

64 ServerIron ADX NAT64 Configuration Guide
53-1002288-02
Applying an ACLs to interfaces
4
DRAFT: BROCADE CONFIDENTIAL
Applying an ACLs to interfaces
Configuration examples in the section “Configuring numbered and named ACLs” on page 46 show
that you apply ACLs to interfaces using the ip access-group command. This section present
additional information about applying ACLs to interfaces.
Reapplying modified ACLs
If you make an ACL configuration change, you must reapply the ACLs to their interfaces to place the
change into effect.
An ACL configuration change includes any of the following:
• Adding, changing, or removing an ACL or an entry in an ACL
• Changing a PBR policy
To reapply ACLs following an ACL configuration change, enter the following command at the global
CONFIG level of the CLI.
ServerIronADX(config)# ip rebind-acl all
Syntax: [no] ip rebind-acl <num> | <name> | all