Specifications
29
ADX-2400N Specifications
Local Inputs
24 Balanced Analog. +4 dB nominal, +24 dBv max. D-25F
connectors wired to Tascam DA-88 / Protools standard
Local Outputs
24 Active Balanced Analog. +4 dB nominal, +24 dBv max. D-25F
connectors wired to Tascam DA-88 / Protools standard
Freq Response 20-20KHz
THD+Noise <0.05% (<0.005% for Rev 3 hardware)
Signal/Noise >100 dB below peak level, bandwidth-limited to 25KHz
A-D and D-A Conversion 24-bit
Output Impedance Approx. 50 Ohms
Input Impedance Approx. 25K Ohms
Digital Processing and Delay 24-bit uncompressed
Cobranet Transmission 20-bit uncompressed
Sample Frequency 48 kHz
Adjustable Delay Range 0 milliseconds to 680 milliseconds (>20 frames at 30 fps)
Minimum Delay (analog in to
analog out)
1 millisecond (0.55 milliseconds for Rev 3 hardware)
Minimum Delay (through
Ethernet)
6.5 milliseconds Normal Mode, 2.25 ms Annc Booth Mode
Headphone Jack 1/4" TRS (Stereo) follows Output selection, Low impedance
Menu Selects Cobranet bundle numbers (address), config store/recall
Remote Control Ethernet port (100baseT) separate from Audio Network.
VU Meter
Conventional VU ballistics (300ms), -20 to +3.5 dB scale, follows
Output selection. Scale mark at 0 VU.
Display 2x24 VFD
Power Requirements 95 to 250 Volts AC, 50-60 Hz, <30 Watts