Specifications

Assigning the ADX120 / ADX140 to be Units A, B, C, or D

The announce units must first be assigned to be devices A, B, C, or D in the

ADX2400 menu. To do this, press the

MENU button once, and select config items

1, 2, 3, and 4 respectively using the knob. When the desired item is selected, press

the

MENU SET button and select the appropriate System ID number for the ADX120

or ADX140 you want to assign. Pressing either SET or MENU will take you back to

the item select mode.

Accessing Remote Menus from the ADX-2400

The configuration items for the ADX-120 and ADX-140 units are accessable from

the front panel of the ADX-2400. To access these remote unit menus, double-click

the MENU button on the ADX2400. The display will say: SELECT REMOTE

DEVICE. The

MENU button will be flashing to indicate that a remote device is being

accessed.

The menu display will look similar to this:

The number in the brackets is the System ID assigned in the ADX-2400 for Unit A

(in this example). If the selected device is present on the network, it's model

number and System ID number will be displayed (ADX120-01 in this example).

Scroll to the desired assigned device (either A, B, C or D).

Press

MENU again. This will access the menu of the remote device, and the menu

might look like this (depending on the type of device and the selected item):

The configuration and status items may be selected using the knob. Once the

desired item is selected, press the

MENU SET button to allow changing that item's

settings. Settings are saved automatically after about 10 seconds of inactivity.

Press either

MENU SET or MENU to go back to the item select mode.

When you're done, the easiest way out of any of the menu modes is to just press the

OUTPUT SELECT button. This will cancel all menu modes, and you won't have to

step backwards out of them.

ADX120-01 Config Item 01

Mic 1 Gain=45dB HR>30dB

Select Remote Device

Unit A [01] ADX120