Specifications
15
To Adjust Headphone Volume
Press the 'HP VOLUME' button, and turn the knob. The bar graph display will show
the knob 'position'.
To Configure Menu Items
The system has several configuration items which may be set by using the menu
function. Press the 'MENU SELECT' button to enable the menu function. Turn the
knob to select the desired menu item, then press the 'MENU SET' button. Turning
the knob will now change the parameter for this item. When the desired selection is
made, you can exit the MENU SET mode by pressing any other button. (See
section on menu items below).
MENU ITEMS - ANNOUNCE BOOTH MODE
Item 01 – ANNOUNCE UNIT A ID = (00-99)
This item selects which physical remote device will appear as Unit A in the ADX-
2400. The mic outputs of the selected device will appear as Mic A1 and A2, the
IFBs will appear as IFB A1 and IFB A2, etc.
The number selected corresponds to the System ID set on the rotary switches of the
remote device. 01 through 99 are valid IDs. 00 is off, and selects no remote device
for Unit A.
Item 02 – ANNOUNCE UNIT B ID = (00-99)
Item 03 – ANNOUNCE UNIT C ID = (00-99)
Item 04 – ANNOUNCE UNIT D ID = (00-99)
Same as above for Units B, C, and D. Note that each remote device on the network
must have a unique ID number, and that a given remote device should only be
assigned once; in other words don't assign the same unit to be both Unit A and Unit
B.
Item 05 - GPI Mode = (Off, Master)
For future or special application use. Should be set to 'Off' normally.
Item 06 - GPI 1/3 Device ID = (00-99)
Item 07 - GPI 2/4 Device ID = (00-99)
For future or special application use. Should be set to '00' normally.