Technical information

2.2.1.3 Control Bridge Assembly

To complete the general removal procedures for the model 8513 display, you

will need to follow these instructions to remove the control bridge

assembly.

1. Refer to Figure 5-1.

2. Unclip and remove the user controls from the control bridge, as shown

in View A.

3. Remove the On/Off switch by pushing down the tab and withdrawing the

switch downward, as shown in View B.

4. Disengage the two latches, and pull the Control Bridge assembly away

from the front bezel.

PICTURE 22

Figure 5-1. Control Bridge Assembly, 8513 Display

Replacement:

Replace the Control Bridge Assembly using the above instructions in

reverse order.

PS/2 Displays Maintenance Manual

Control Bridge Assembly

2.2.1.3 - 1