Technical information

2.1.1.4 Signal Cables

1. Refer to Figure 4-1 in topic 2.1.1.3.

2. Remove the connectors 5 from the signal cable to the video card and

the associated ground lead.

3. Remove the two screws 9 and move the tab 10 to release the analog

card. Lift the card at the rear to clear the locating pin and ease it

away from the retaining lugs on the front of the card tray assembly.

4. Remove the clamp screws at each end of the cable 7 , and remove the

lead from the braid to ground.

5. Note how each clamp is fitted on the cable before removing the signal

cable from the retention tabs.

PICTURE 17

Figure 4-3. Signal Cable Clamps, 6318/8511/8518 Displays

Replacement:

1. Ensure that the front clamp makes contact with the braid and the cable

sheath because it acts as a strain relief for the cable.

2. Replace the cable in the retention tabs so that the longer section of

braid is aligned with the rear clamp. This clamp is attached to the

braid only.

PS/2 Displays Maintenance Manual

Signal Cables

2.1.1.4 - 1