Technical information

1.3.6 Signal Cable

The signal cable transmits signals to the display from the computer

processor. This cable is clamped to the card tray and must be unclamped

to clear the card tray assembly from the cable.

Several of the clamps and card trays are different, however. Procedures

for clearing the signal cable from the card tray assemblies of specific

display models are presented "Part II. Display-Specific Service

Information."

To remove the signal cable clamps:

1. Power off the system and the display, and disconnect all cables (see

"Powering Off the System" in topic 1.1.3).

2. Remove the tilt swivel stand (see "Tilt Swivel Stand" in topic 1.3.1),

or the lift tilt swivel stand (see "Lift Tilt Swivel Stand" in

topic 1.3.2).

3. Remove the rear cover (see "Rear Cover" in topic 1.3.3).

4. Refer to "Part II. Display-Specific Service Information" for detailed

instructions and illustrations for removing the cable clamps from the

type of display you are servicing.

PS/2 Displays Maintenance Manual

Signal Cable

1.3.6 - 1