Technical information

6. Do not touch any conductive parts when discharging high voltages.

Insert the blade of the screwdriver under the suction cup until the

end touches the anode lead connector 4 .

PICTURE 11

Figure 3-7. Discharge High Voltage to CRT Ground

7. Do this several times to ensure a complete discharge.

8. Carefully remove the anode suction cup from the CRT.

Note: Remove the anode suction cup immediately after discharge, to

prevent the CRT capacitance from recharging. If you are delayed

for more than a minute or two, perform the discharge procedure

again.

PS/2 Displays Maintenance Manual

High Voltage Discharge Procedure

1.3.4 - 2