Technical information

1.3.3.2 Rear Cover, Type 2

The removal procedures for this type of rear cover are:

1. Turn power off at the system unit and the display, and disconnect all

cables (see "Powering Off the System" in topic 1.1.3).

2. Remove the tilt swivel stand (see "Tilt Swivel Stand" in topic 1.3.1),

or the lift tilt swivel stand (see "Lift Tilt Swivel Stand" in

topic 1.3.2).

3. Refer to Figure 3-4.

4. Remove the covers 1 from the two securing screws 2 on the top of

the rear cover 3 .

5. Remove the four screws 2 from the rear cover.

6. Ease the rear cover away from the display.

PICTURE 8

Figure 3-4. Removing the Rear Cover, Type 2

Replacement:

Replace the rear cover using these instructions in reverse order.

PS/2 Displays Maintenance Manual

Rear Cover, Type 2

1.3.3.2 - 1