Technical information

1.3.3.1 Rear Covers, Type 1

The removal procedures for this type of rear cover are:

1. Power off the system and the display, and disconnect all cables (see

"Powering Off the System" in topic 1.1.3).

2. Remove the tilt swivel stand (see "Tilt Swivel Stand" in topic 1.3.1),

or the lift tilt swivel stand (see "Lift Tilt Swivel Stand" in

topic 1.3.2).

3. Refer to Figure 3-3.

4. Remove the two securing screws 1 from the rear cover.

Some models have only a single hex head screw on the bottom of the display

that must be removed. Additionally, these covers may require that you

unclip two plastic closing plates from the interface cable to allow the

plug to pass through the cover.

5. Insert the delatching tools 2 into the slots to release the

fasteners.

6. Ease the rear cover 3 away from the display, after disengaging the

signal cable from the retention slot.

PICTURE 7

Figure 3-3. Removing the Rear Cover, Type 1

Replacement:

Ensure that the securing arms of the card tray assembly are latched into

the front cover.

PS/2 Displays Maintenance Manual

Rear Covers, Type 1

1.3.3.1 - 1