Technical information

1.3.2 Lift Tilt Swivel Stand

The other type of stand for the PS/2 Displays is the lift tilt swivel

stand. Remove it by following these steps.

1. Power off the system and the display, and disconnect all cables (see

1.1.3).

2. Carefully place the display upside down on a clean surface.

3. Remove the lift tilt swivel stand by moving the lever in the direction

of the arrow, and disengaging the latches from the base of the

display.

PICTURE 6

Figure 3-2. Removing the Lift Tilt Swivel Stand

Replacement:

Replace the lift tilt swivel stand by using these instructions in reverse

order.

PS/2 Displays Maintenance Manual

Lift Tilt Swivel Stand

1.3.2 - 1