Technical information

1.3.1 Tilt Swivel Stand

The tilt swivel stand is the same for most models, but some have a

different method of attachment and some lift as well as tilt and swivel.

1. Power off the system and the display, and disconnect all cables. (See

"Powering Off the System" in topic 1.1.3.)

2. Place the display on its front cover, protected with a soft cloth or

similar material.

3. Remove the thumbscrew 1 , disengage the locating hooks 2 , and move

the tilt swivel stand away from the display.

PICTURE 5

Figure 3-1. Removing the Tilt Swivel Stand

Other displays have a tilt swivel stand that is held on with two release

clips. For those types of stands, use these instructions after powering

off the system and removing all cables.

1. Place the display on a flat surface, ensuring that there is sufficient

space to set the display down after removing from the stand.

2. Press the two release clips at the front of the stand assembly.

3. Pull the display forward from the tilt swivel stand.

4. Lift the display from the stand and place it on a flat surface.

Replacement:

Replace the tilt swivel stand by using these instructions in reverse

order.

PS/2 Displays Maintenance Manual

Tilt Swivel Stand

1.3.1 - 1