Technical information

2.7.1.4 Signal Cable

1. Refer to Figure 10-1 in topic 2.7.1.3.

2. Remove the signal cable connector and its associated ground lead 5 ,

from the video card.

3. Remove the two screws 9 and move the tab 10 to release the analog

card. Lift the card at the rear, to clear the locating pin, and ease

it away from the retaining lugs on the front of the card tray

assembly.

4. Remove the clamp screws at each end of the cable 7 , then remove the

lead from the cable braid from the ground point.

5. Note how each clamp is fitted on the cable before removing the signal

cable from the retention tabs.

PICTURE 60

Figure 10-3. Signal Cable Clamps, 9518 Display

Replacement:

1. Ensure that the front clamp makes contact with the braid and the cable

sheath, because it acts as a strain relief for the cable.

2. Replace the cable in the retention tabs so that the rear section of

braid is aligned with the rear clamp. This clamp is attached to the

braid only.

PS/2 Displays Maintenance Manual

Signal Cable

2.7.1.4 - 1