Technical information

2.6.2.3.3 Preliminary Steps

Proceed as follows.

1. Insert the Color Displays Test-Pattern diskette into drive A of the

system unit.

Note: The Test-Pattern Diskette is used for setting up the 9515 Color

Display.

CAUTION:

Use caution when making adjustments with the cover removed. There are

high voltages on the analog and video cards.

2. Power on the system unit and the display. The system unit runs its

internal checks, and then loads the program from the diskette.

Note: The following error codes might appear. Do the actions

specified to solve the problem.

 ASP001E: Cannot Open Adapter

The setup program has detected that the display is attached to the

PS/2 planar VGA port.

To continue testing in VGA modes only, type VGA at the A: DOS prompt

and press Enter

 ASP002E: Cannot Open Display

The setup program has detected that a display adapter is installed in

the system, but cannot find a display attached.

a. Power off the system unit.

b. Check that the display to be tested is attached to the adapter

that is closest to slot 1.

c. Power on the system unit.

Alternatively, remove all adapters not needed for the test,

reconfigure the PS/2 and retry the setup test.

3. With the Brightness control set to center detent (midpoint), adjust G2

and Focus until the setup menu is visible. Select pattern C and press

the keyboard spacebar until the black field is selected. Adjust the

G2 control to give minimum background illumination.

4. Allow 20 minutes for the display to warm up before making any further

adjustments.

5. Set the Contrast control to midpoint.

PS/2 Displays Maintenance Manual

Preliminary Steps

2.6.2.3.3 - 1