Technical information

1.1.2 Operator Controls and Power-On Indicator
.
PICTURE 2
Figure 1-1. Example Operator Controls
All PS/2 Displays have operator controls and power-on indicators similar
to those shown in Figure 1-1. On some older displays, the controls
perform the same functions but are not located at the same places.
When the power switch is set to off, the pushbutton is level with the
surface of the control panel. Press the pushbutton 1 to switch on the
display. Press again to switch off; the pushbutton returns to its
original position.
On the older model displays, the power switch is located on the right side
of the display. Push the lever-action switch in to switch on the display.
To turn off the display, push in the opposite side of the switch.
Subtopics
1.1.2.1 Contrast Control
1.1.2.2 Brightness Control
1.1.2.3 Power-On Indicator
PS/2 Displays Maintenance Manual
Operator Controls and Power-On Indicator
¦ Copyright IBM Corp. 1993
1.1.2 - 1