Technical information

2.5.2.4.7 Focus and Convergence

Select mode 4 (or mode 3 if not available) to display the test patterns.

1. Select option 1, pattern A (Crosshatch),

2. Adjust the focus control on the video shield to focus the vertical

lines.

3. Adjust the focus control on the EHT transformer to focus the

horizontal lines.

4. Press PF3 to return to the setup patterns. Select option 5, pattern E

(Focus Pattern), to check the focus settings.

5. Press PF3 to return to the setup patterns. Select option 1, pattern A

(Crosshatch), and press the spacebar to get a white crosshatch

pattern.

6. Adjust the H.STAT control on video shield to set convergence.

This completes the alignment procedures.

PS/2 Displays Maintenance Manual

Focus and Convergence

2.5.2.4.7 - 1