Technical information

2.5.1.5.2 Analog Card

Proceed as follows.

1. Refer to Figure 8-5.

2. Remove two screws 1 .

3. Release the two cable ties 2 on the pod cable and the power cable.

4. Move the analog card away from the retaining mounts 3 and lift it

out.

PICTURE 36

Figure 8-5. Removing the Analog Card, 8517/9517 Displays

Replacement:

Ensure the connector to the analog card is put through the slot at the

front of the card tray.

Note: Geometry adjustments are required after replacing the analog card.

PS/2 Displays Maintenance Manual

Analog Card

2.5.1.5.2 - 1