Technical information

2.5.1.5.1 Card Tray

Proceed as follows.

1. Place the display on its front cover, protected by a soft cloth or

similar material.

2. Refer to Figure 8-4.

3. Remove the connector 1 from the analog card and release the cable

tie on the card tray lug.

4. Remove connector D21 (9517 only).

5. Remove two screws 2 from the card tray lugs and the ground lead 4

(9517 only).

6. Move the card tray away from the ITC shield and remove the connector

3 from the analog card.

CAUTION:

Take care not to damage the neck of the CRT.

Observe all safety notices for handling CRTs.

PICTURE 35

Figure 8-4. Removing the Card Tray, 8517/9517 Displays

Replacement:

Ensure that the connectors to the analog card are replaced and check that

all of the other analog card connectors are in place.

PS/2 Displays Maintenance Manual

Card Tray

2.5.1.5.1 - 1