Technical information

2.5.1.3 Pod Assembly

The pod contains the control and filter cards.

1. Refer to Figure 8-1

2. Remove the three screws 1 securing the pod.

3. Disconnect the earth lead 2 from the card tray.

4. Release the two latches 3 with a flat-blade screwdriver and ease the

pod back.

5. Remove the power connector 4 from the filter card to the analog

card.

6. Remove the connector 5 from the control card to the analog card.

PICTURE 32

Figure 8-1. Removing the Pod Assembly, 8517 Display

Replacement:

Replace the Pod Assembly using the above instructions in reverse order.

PS/2 Displays Maintenance Manual

Pod Assembly

2.5.1.3 - 1