Service manual

06/2010

outside of the heat exchanger and the heat exchanger other side is resting on the ledge of the

burner assembly. See figure -8.

6. Be sure the table is level. Place a level on the burner bracket. Adjust the burner assembly until

it is level and mark the heat exchanger through the two mounting holes in the burner bracket.

7. Remove the burner assembly and drill ¼” holes at the two marked holes on the heat exchanger.

8. Again place the burner on the heat exchanger. From the inside of the heat exchanger assemble

the heat exchanger backup plate through the two holes of the heat exchanger and burner. Use

the two new 8-32 self-locking screws 1397 and a 3/8” open end wrench to tighten the assembly.

Recheck that the upside down assembly is still level as determined in step 6.

9. Reverse the procedure of steps 3, and 2 to complete assembly.

10. Check the unit for normal operation per SM500-16 ‘Testing the RV500’

Kit Parts List:

1315 Burner assembly

Figures:

Figure-3 Frontal View of RV500 with Door Removed

Figure-4 View of Electronic Drawer

Figure-8 Heat Exchanger / Burner Assembly Method

Model: RV500-F-L / RV501-F-L

SM500-11 Igniter Replacement