Service manual

06/2010

3. Note: Model 500 with serial numbers prior to 97-07-xxxx.

Remove the four sheetmetal screws located two on each side of the case. The head of the

screw is accessed from the outside of the case. If the screws are not accessible then the

case must be pulled from the RV sufficiently to access the screws.

Note: Model 500 with serial numbers after 97-07-xxxx and ALL MODEL 501

Using a Phillips screwdriver remove the 8-32 screw located at the middle rear of the hood (see

figure -3). Then remove the two 8-32 screws located at the upper front of the hood. These

screws are accessible through holes in the lower hood that have been covered with metal tape.

Note: Model 500 with serial numbers starting with 05-XX-XXXX remove the two 8-32 screws

located at the upper front of the hood. These screws are accessible through holes in the lower

hood that have been covered with metal tape

4. Lift the hood until it clears the heat exchanger and then bring the hood forward to

remove it from the case.

5. Slide the electrical drawer into the new hood.

6. Install the new hood reversing steps 4, 3, and 2.

Kit Parts List:

Hood assembly 1327