Service manual

06/2010
3. Slide the drawer forward to reveal the two circuit boards AS 1312 and EB 1378. Wire harnesses
will not permit the drawer to be removed. Disconnect the one connection to EB 1378 and the five
(5) connections to AS 1312. All electrical connectors in the drawer should now be disconnected
and the drawer can slide out of the guides.
4. Route the wire harnesses through the grommets of the new drawer. Be sure to route the ignition
harness separate from the other control harnesses. Then slide the drawer unto the guides.
5. Re-connect the nine (9) electrical connections.
6. Perform a test of the unit. Refer to SM500-16 ‘Testing the RV500’.
Kit Parts List:
1438 Assembly, Electrical Drawer
Figures:
Figure-3 Frontal view of RV500 without door
SM500-04 Hood Change Procedure
Other service documents required:
None
Tools Required:
Phillips screwdriver
1. Turn off power.
2. Open the electrical drawer and disconnect the two connectors on the DSI board EB 1378 and the
five connectors on the circuit board AS 1312 (refer to figure -4). Route the cables out of the
drawer and then slide the electrical drawer out.