Service manual

06/2010
4. Install the new board with the LEDs located at the front of the drawer. Reconnect all connectors
to the board. CAUTION: there are two two-pin connectors. Be sure that the power supply
connector (red and black wire) goes to upper left corner and the valve connector (white and
black wire) goes to upper right (see figure -4).
5. Put the LED holders in.
6. The set temperature is already at 122F. Refer to manual if a further adjustment is desired.
7. You must run AutoCal to complete the installation. Refer to SM500-15.
8. Perform a test of the unit. Refer to SM500-16 ‘Testing the RV500’.
Kit Parts List:
1841- RV Control Board
Figures:
Figure-4 View of
the Electronic Drawer
Model: RV500-F-L / RV501-F-L
SM500-02 Direct Spark Ignition (DSI) Board Change
Other service documents required:
none
Tools Required:
¼” socket
5/16”wrench
Velcro strips
1. Turn off power. Disconnect all electrical connectors at the DSI board.