Service manual

06/2010
Model: RV500-F-L / RV501-F-L
Schematic RV500 2004 - present
SM500-01 Circuit Control Board Replacement
Other service documents required:
SM500-15 Automatic calibration (AutoCal)
SM500-16 Testing the RV500
Tools Required:
Needle-nose pliers
1. Turn off power. Disconnect all electrical connectors at the circuit board.
2. Remove the circuit board. A needle-nose plier can be used to remove the circuit board
standoffs.
3. Remove the two black LED holders (if necessary) so they will not interfere with the installation of
the new board.