Service manual

06/2010
PrecisionTemp
Authorized RV500 Service Schedule
The following figures are standard time requirements allowed for repair or
replacement of components. Warranty service charges time exceeding these
standards will not be paid unless prior approval is obtained from PrecisionTemp.
Service charges will be paid in tenths of an hour (six minute increments)
General Trouble-Shooting ………… Maximum of 30 minutes (0.5 hour)
Repair or replacement of components Hours
SM500-01 Circuit board (includes AutoCal) (1841-RV) 0.3
SM500-02 DSI (3158) 0.3
SM500-03 Electrical drawer 0.0
SM500-04 Hood 0.0
SM500-06 Heat exchanger assembly (1435) 0.0
SM500-07 T-in (1436) 0.3
SM500-08 T-mid (2008) 0.3
SM500-09 T-out (1437) 0.3
SM500-10 Burner 0.0
SM500-11 Igniter (1411) 0.0
SM500-12 Flowmeter assembly (1330) 0.8
SM500-13 Gas solenoid (1073) 0.8
SM500-14 Modulating valve (incl. AutoCal) (1076) 0.9
SM500-15 Automatic calibration (AutoCal) 0.2
SM500-16 Testing the RV500 0.2
Failure of the RV500 to work properly as a result of improper installation, or
conditions caused by non-PrecisionTemp components is not covered by warranty.
In the event the estimated warranty time required to service the RV500 would
exceed the authorized schedule it is necessary that PrecisionTemp Technical
Support be contacted for approval. Without this approval service charges will be
paid at the published schedule.