Please Read and Save this Use and Care Book Register your product online at www.prodprotect.com/applica, for a chance to WIN $100,000! For US residents only USA/Canada 1-800-LITMAID www.littermaid.
WELCOME TO THE FAMILY! Congratulations on your purchase of the LitterMaid Elite™ Advanced Automatic Self-Cleaning Litter Box. This product is designed to make caring for your cat a simpler, less time-consuming process. OPERATING INSTRUCTIONS FOR THE LITTERMAID™ SELF-CLEANING LITTER BOX • Cat enters the unit; once he/she leaves, the sensors are triggered, setting the timer for the cleaning cycle. (Sensors need to be blocked for at least 5 seconds.
Accessories Product may vary slightly from what is illustrated. 5 4 3 6 7 7 8 9 2 1 10 6 1 16 3 2 11 15 1. 2. 3. † 4. 5. 6. 7. † 8. † 9. 10. † 11. † 12.
Setup Instructions Accessories Check our online service for parts and accessories at www.littermaid.com or call 1-800-548-6243 Model # LitterMaid Kitty Kabana™ litter box cover LitterMaid Elite™ litter box cover LitterMaid® litter box carpet LMT200 LitterMaid® premium clumping cat litter LML100 Disposable waste receptacles (12 pk.) LMR200 Disposable waste receptacles (18 pk.) LMR300 Carbon filters (12 pk.) LMF200 LMT250 No Tools Required for Setup • Unpack the pieces of the unit listed below.
Assembly 1. Slide receptacle supports (marked L (left) and R (right)) into grooves on the bottom tray until they lock into place (A). A 2. Place both left and right flaps flat on top of the waste receptacle compartment panel. Make sure lid edges are under the cover tabs (J). J 3. Push the flaps in and up until they click into place (B). 9. Install carbon filter. • Peel off the paper strip on the carbon filter to expose the adhesive.
Install rake 12. Align tracks on back of rake (each end) and slide into grooves on motor housing (R). R Sensors (located on interior side panels) must be kept clean. Wipe sensors with a soft, dry cloth to keep them dust free (U). U 13. Remove the AC adapter from where it is packed in the styrofoam and plug it into the unit (S). • Plug the cord into a standard electrical wall outlet. • Press the ON/OFF button to turn unit ON.
Care and Cleaning Sensor Covers The two sensors located on the interior side panels are protected by sensor covers that need to be kept dust free. After changing or adding litter, wipe each sensor with a soft, dry cloth to remove dust. Litter Tray Use only premium clumping litter. Lesser quality litters will impair performance. To empty and clean litter tray: • Check to make sure rake is in home position. • Press the ON/OFF button to turn unit OFF.
Troubleshooting Rake continues to go through cleaning cycles. Probable Cause: • Too much litter in the litter box is causing excess litter to collect behind the rake, preventing it from returning to home position or there is an obstacle in front at the rake. If the rake cannot move an obstacle during the cleaning cycle, the unit will go through a cleaning cycle up to five times in an attempt to clear the obstacle.
5. If unit does not operate with fresh batteries, try it with the AC adapter. Probable Cause: 6. Green light should come on. If it does not, there is a problem with the AC adapter or batteries. • Power outage or batteries are incorrectly installed or dead. Probable Cause: • AC adapter does not work. Solution: Press ON/OFF button OFF and check the following: 1. The AC adapter plug is inserted fully into the input jack. 2. The power outlet is operating.
Solution: 1. Press ON/OFF button OFF. 2. Unplug unit. 3. Remove batteries. 4. Clean unit (check track for litter). 5. Wipe sensors. 6. Put unit together and plug into AC power only and press ON/OFF button to turn unit ON for the automatic cycle. If green ionize LED is off. Solution: • Ionizer only turns on during 10 minute countdown and raking cycle. 17 NEED HELP? For service, repair or any questions regarding your appliance, call the appropriate "800" number on the cover of this book.
Copyright © 2008 Applica Consumer Products, Inc.
