Installation guide

5500

and rearmed, and still allow NPC to bypass a faulty zone.

When disarming the system, 5 chirps indicate NPC is activated. The LED will report the zone that has been

bypassed. (See

Diagnostics

section of this guide.)

vvaalleett mmooddee

TToo eenntteerr oorr eexxiitt vvaalleett mmooddee wwiitthh tthhee vvaalleett//pprrooggrraamm sswwiittcchh::

1. Turn the ignition key on and then off.

2. At anytime during the next 10 seconds, press and release the Valet switch. Now the Status

LED will light constantly if you have entered Valet Mode, and go out if you have exited

Valet Mode.

TToo eenntteerr oorr eexxiitt vvaalleett mmooddee wwiitthh tthhee ttr

raannssmmiitttteerr::

To enter or exit Valet Mode with a transmitter:

1. Open any door.

2. Press on the transmitter.

3. Press .

4. Press again. You have now entered or exited Valet Mode (verify by checking your status LED).

rreeaarr ddeeffooggggeerr ccoonnttrrooll

The rear defogger output can be remotely turned on/off any time using the remote control. The default setting

OONN

To turn the rear defogger output OFF:

1. Press & release the and and buttons of the remote control.

2. The parking lights will flash 2-times.

3. The rear defogger output will no longer activate when the vehicle is remote started.

NNOOTTEE::

If the remote start is On the lights will turn off then flash 2-times before returning to

their normal output and the defogger output, if active, will cease.