Installation guide

4455

11--88 FFOORRCCEEDD PPAASSSSIIVVEE AARRMMIINNGG OONN//

OFF

To use this feature, passive arming must be selected in Feature 1-1. When

turned on, forced passive arming will ensure that the system will passively arm, even if a zone is left open or

invalid. Forced passive arming occurs one hour after the ignition is turned off.

11--99 AAUUTTOOMMAATTIICC EENNGGIINNEE DDIISSAABBLLEE ((AAEEDD))

//OOFFFF

: AED is a full-time, passive starter disable that works independ-

ently of the security system. When turned on, the orange, ground-when-armed output (H1/1) will activate 30

seconds after the ignition is turned off. The LED will flash at half its normal rate when the ignition is turned off

to indicate that AED is active and will interrupt the starter in 30 seconds. AED does not occur in Valet mode and

can be bypassed using the emergency override procedure. The transmitter can be used to disarm AED, however,

the system must be armed and then disarmed, using the transmitter, to disarm AED.

11--1100 AARRMMEEDD WWHHIILLEE DDRRIIVVI

INNGG ((AAWWDD)) OONN//

OFF

In the default setting (Armed While Driving), the system can be

armed with the ignition on. When armed, the ground-when-armed is not active and the sensors are bypassed. The

door triggers will remain active.

11--1111 CCOODDEE HHOOPPPPIINNGG®® OONN//OOFFFF::

The system uses a mathematical formula to change its code each time the trans-

mitter and receiver communicate. This makes the group of bits or "word" from the transmitter very long. The

longer the word is, the easier it is to block its transmission to the unit. Disabling the Code Hopping® feature lets

the receiver ignore the Code Hopping® part of the transmitted word. As a result, the unit may have better range

with Code Hopping® off.

11--1122 HHOORRNN OOUUTTPPUUTT PPUULLSSEEDD//

CONSTANT

Program for either a pulsed output or a continuous output when trig-

gered.

11--1133 HHOORRNN FFUUNNCCTTIIOONN ((FFUUL

LLL AALLAARRMM OONNLLYY))//

SIREN FUNCTION (20mS, 30mS, 40mS, 50mS): Program for output

when the alarm is fully triggered or as the siren (arming/disarming and warnaway and full trigger with timing

options).

11--1144 CCOOMMFFOORRTT CCLLOOSSUURREE——

,, OOFFFF::

The system can be programmed to close the windows when the system is armed.

A 20-second output starts 200mS after the last lock pulse. The Comfort Closure output will be canceled if the unlock

button is pressed. If programmed ON, the lock output wire provides this function.

22--11 SSIIRREENN DDUURRAATTIIOONN 3300//

SSEECCOONNDDSS::

It is possible to program the unit to sound for 30 or 60 seconds

during the triggered sequence. Some states have laws regulating how long a security system can sound.

When using the Bitwriter®, the siren can be programmed to sound for any length of time from 1 second to 180

seconds.

mmeennuu ##22 -- aaddvvaanncceedd ffeeaattuurreess