Installation guide

ManualsBrandsApplica ManualsCoffee MakerAM7

3366

CChhoooossee..

Within 10 seconds, press and release the Program switch the number of times cor-

responding to the desired channel listed below. Once you have selected the channel, press

the switch once more and

HHOOLLDD

it. The LED will flash and the horn will honk (if connected)

to confirm the selected channel. Do not release the Program switch.

TTrraannssmmiitt..

While

HHOOLLDDIINNGG

the Valet/Program switch, press the button on the transmitter

that you would like to control the selected receiver channel. The unit will chirp to confirm

that the code has been successfully programmed. It is not possible to teach a transmitter

button to the system more than once.

RReelleeaassee..

Once the code is learned, the Valet/Program switch can be released.

You can advance from programming one channel to another by releasing the Valet/Program switch and tapping

it to advance channels and then

HHOOLLDDIINNGG

it. For instance: You have programmed Channel 1 and you want to

program Channel 2. Release the Valet/Program switch. Press it one time and release it to advance from Channel

1 to Channel 2. Now, press and

HHOOLLDD

the Valet/Program switch. The LED will flash two times and the horn will

honk twice (if connected). As before, do not release it.

CCHHAANNNNEELL NNUUMMBBEERR FFUUNNCCTTIIOONN WWIIRREE CCOOLLOORR

1 Auto Learn Standard Configuration

(default)

2 Arm only

3 Disarm only

4 Silent Mode™/Remote Valet/Trunk Release RED/WHITE

5 Remote Start

6 Channel 4 VIOLET/BLACK

7 Channel 5 WHITE/BLACK

8 Channel 6

9 Short Run/Turbo

10 Timer Mode

11 Arm/Disarm/Panic

12 Panic only

Defogger Control

14 Delete all transmitters**

**NNOOTTEE::

For Auto Learn Configurations, see Transmitter Configurations section of this guide.

**NNOOTTEE::

If any button from a known transmitter is programmed to Channel 13, all trans-

mitters will be erased from memory and will revert to the default feature settings. This

is useful in cases where the customer's transmitters are lost or stolen.