Installation guide

2211

((--)) LLiigghhtt FFllaasshh OOuuttppuutt

NNOOTTEE::

For parking light circuits that draw 10 amps or more, the internal jumper must be

switched to a (-) light flash output. (See the Internal Programming Jumper section of this

guide.)

PP//NN 88661177

or a standard automotive SPDT relay must be used on the H1/2 light flash

output harness wire.

This wire supplies a (-)500 mA ground as long as the system is armed. This output ceases as soon as the system

is disarmed. The orange wire may be wired to an optional Directed Electronics 8618 starter kill relay.

sseeccoonnddaarryy hhaarrnneessss ((HH22)) wwiirree ccoonnnneeccttiioonn gguuiiddee

This wire produces a (-) 200mA output for progressive locks in which the driver door unlocks first and the remain-

ing locks unlock with a second press of the unlock button.

This wire provides a (-) 200mA output whenever the transmitter button(s) controlling Channel 5 is pressed. This

output can be programmed to provide the following types of outputs (see also the

Feature Descriptions

section):

■

VVaalliiddiittyy

: Output that will send a signal as long as the transmission is received.

■

LLaattcchheedd

: Output that will send a signal when the Channel 5 button(s) is pressed and will continue until the

same button(s) is pressed again.

■

LLaattcchheedd,, rreesseett wwiitthh iiggnniittiioonn

: Similar to the latched output, this type of output turns on the first time the

Channel 5 button(s) is pressed and turns off the next time the same button is pressed. This type of output

additionally stops and resets whenever the ignition is turned on and then off.

HH22//22 WWHHIITTEE//BBLLAACCKK 220000 mmAA pprrooggrraammmmaabbllee ((--)) cchhaannnneell 55 oouuttppuutt

HH22//11 LLIIGGHHTT BBLLUUEE 220000mmAA ((--)) 22

nndd

uunnlloocckk oouuttppuutt

HH11//1122 OORRAANNGGEE ((--)) ggrroouunndd--wwhheenn--aarrmmeedd oouuttppuutt