Installation guide

2200

This input comes from the factory set to 2 activation pulses. This means that it is necessary to have 2 consec-

utive ground pulses on the white/blue wire for the remote start to activate or to deactivate. The same holds true

for the remote control activation when set to a two pulse setting it is necessary to press the button twice

for the remote start to activate or deactivate.

NNOOTTEE::

When the activation pulse count can be programmed to 1, 2, or 3 pulses when changed

it will affect both activation inputs; the White/Blue wire and the remote control activation.

As shipped, this wire should be connected to the (+) parking light wire. If the light flash polarity jumper under

the sliding door is moved to the opposite position (see

Internal Programming Jumper

section of this guide), this

wire supplies a (-) 200 mA output. This is suitable for driving (-) light control wires in Toyota, Lexus, BMW, some

Mitsubishi, some Mazda, and other model cars.

((++)) PPoossiittiivvee LLiigghhtt FFllaasshh OOuuttppuutt

HH11//1111 WWHHIITTEE ((++//--)) sseelleeccttaabbllee lliigghhtt ffllaasshh oouuttppuutt

HH11//1100 WWHHIITTEE//BBLLUUEE rreemmoottee ssttaarrtt ((--)) aaccttiivvaattiioonn iinnppuutt