Installation guide

1177

pprriimmaarryy hhaarrnneessss ((HH11)) wwiirree ccoonnnneeccttiioonn gguuiiddee

When the system receives the code controlling Channel 2, for longer than 1.5 seconds, the red/white wire will

supply an output as long as the transmission continues. This is often used to operate a trunk/hatch release or

other relay-driven function.

IIMMPPOORRTTAANNTT!!

Never use this wire to drive anything but a relay or a low-current input! The tran-

sistorized output can only supply 200 mA of current. Connecting directly to a solenoid, motor,

or other high-current device will cause it to fail.

Before connecting this wire, remove the supplied fuse. Connect to the battery positive terminal or the constant

12V supply to the ignition switch.

NNOOTTEE::

Always use a fuse within 12 inches of the point you obtain (+)12V. Do not use the 15A

fuse in the harness for this purpose. This fuse protects the module itself.

HH11//22 RREEDD ((++))1122VV ccoonnssttaanntt ppoowweerr iinnppuutt

HH11//11 RREEDD//WWHHIITTEE cchhaannnneell 22,, 220000mmAA ((--)) oouuttppuutt