Installation Guide

13
INSTALLING THE ANTI-TIP BRACKET
IMPORTANT!
zz
Use the proper screws to fix the stability bracket in place according to the type of material on the floor and/or wall.
zz
Before drilling and holes or inserting any screws into the floor or wall check that you will not damage any wiring orpipes.
3 Fix the stability bracket in place. It can be fixed as follows:
zz
To the floor OR on the rear wall by #4 screws (supplied).
zz
To the floor AND on the rear wall by #8 screws (supplied).
zz
There are 8 x wood screws and 8 x screws with plastic sleeve anchors supplied with the range in two separate kits.
Usetheproper screws according to the type of material on the floor and/or wall.
zz
If using the the plastic sleeve anchors: drill 5/16" (8mm) diameter holes and insert the supplied plastic sleeve anchors
beforeattaching the stability bracket with thescrews.
4 Slide the range into place, ensuring the bolt on the adjustable bracket slots under the stability bracket.
zz
Adjust the length of the bolt as necessary. Ensure the two nuts are well tightened after any adjustments.
=
=
Dotted line showing the position
of the range when installed
17 15/16"
(456mm)
=
=
Stability
bracket
Adjustable
bracket with
bolt correctly
fitted
=
=
Stability
bracket