Owner's Manual

14 INSTALLATION
Dimensions and Clearances
•
Check the dimensions of the appliance and the
installation path to ensure there is sufcient room to
move the refrigerator through doors or narrow
openings.
•
If an opening is too narrow to t the refrigerator
through, remove the refrigerator doors. See
Removing/Assembling the Doors and Drawers in
this manual.
•
The installation location chosen for the refrigerator
should allow space behind the unit for connections
and airow and space in front to open the doors and
drawers.
•
Too small of a distance from adjacent items may
result in lowered freezing capability and increased
electricity consumption charges. Allow at least 22.6
inches (575 mm) in front of the refrigerator to open
the doors, and at least 2 inches (50.8 mm) between
the back of the refrigerator and the wall.
A
B
C
E
H
G
D
F
-
Dimensions/
Clearances
LRKNS1205V
A Width 26 1/4″ (666 mm)
B Height to Top of
Case
69 3/8″ (1762 mm)
C Height 71″ (1802 mm)
D Back Clearance 2″ (50 mm)
E Depth without Door 24 5/8″ (625 mm)
F Depth 29″ (737 mm)
G Depth (Total with
Drawer Open)
45″ (1142 mm)
H Depth (Total with
Door Open 90°)
51 11/16″ (1312 mm)
Removing/Assembling
Refrigerator Doors
Removing the Top Refrigerator Door
1
Remove the top hinge cover screw
a
. Lift the
hook (not visible), located at the bottom of the
front side of the cover
b
, with a Phillips
screwdriver.
a
b
2
Remove PCB cover screw
c
and lift cover
d
.
3
Detach all the wire harnesses
e
and remove
Ground screw
f
.
e
f
d
c
Ground
screw
NOTE
•
The number of wire harnesses may vary depending
on the model.
4
Remove top hinge screw
g
and lift off the top
hinge
h
.
CAUTION
•
When lifting the hinge free, be careful that the
door does not fall forward.
g
h