Installation Instructions

English 27
Installation
STEP 10 Securing
1. Check the parts on the sink to which the drain hose will be connected.
2. There are several ways to insert the drain hose into the drain hose connector of the
sink, as shown in the following gures. You must connect the drain hose in accordance
with the water pipe installation regulations in your region.
Figure 8
Case 1. Without disposal
Air gap
Hose clamp
Drain
hose
Hose clamp
Without disposal With an air gap/without disposal Without an air gap
Case 2. With disposal
Air gap
Hose clamp
Drain
hose
Hose clamp
With disposal Disposal with an air gap Without an air gap
3. Check the size of the sink’s drain hose connector. If needed, cut the drain hose so its
end ts onto the sink connector (
5
/8 in. or 1 in. - as shown in Figure 9 below). If the end
of the drain hose does not t onto the drain hose connector of the sink, use an adaptor
purchasable at a plumbing/hardware supply store.
DW8000R_DD68-00210A-00_EN.indd 27 4/25/2019 11:11:05 AM