Cut Sheet

Industrial Mercmaster
™
LED Low Profile Luminaires
For Ordinary Locations
NEC/CEC:
cCSAus Listed
Type 3R, 4, 4X
IP66/IP67
NEC/CEC:
Simultaneous Exposure
Suitable for Use in Wet Locations
Marine Outside Type (Salt Water)
For USA ONLY  
International Dark Sky (IDA) Approved
Illustrated Features
Heatsink
Reliableheattransferviathecast,epoxy
powdercoataluminumbody.Provides
maximumheatdissipationfromtheLED
assemblytotheoutsideenvironment.
Driver Assembly
Utilizingnon-sparkingcomponents
avoidingtheignitionofgasesorvapors
thatmaybepresent.
Cooler Operating Cone Hood
Largerslopedsurface
shedsdusts,dirtand
combustiblefibers
providingbetterheatdissipation.
Fuses (optional)
Fusesfactory
installedinluminaire
housing.Use of
fuse voids Marine
Outside Type (salt
water) rating.
Watertight Pendant
Hood
RedesignedPendant
hoodprovides
protectionagainstwater
ingressintheconduit
utilizinganIP68cord
gripwiththreewireholes
4mmindiameter.
Photocell (optional)
FactoryInstalledintheMountingHood.
Availableforallfixturesexceptcone
andceilingmount.Providescontinuous
ON-OFFdusk-to-dawncontrol.Note:
Fixtures with PCD2 photocontrols are
not rated IP66, Type 4X, Marine Outside
Type (Salt Water), but are suitable for wet
locations.
Terminal Blocks
Aseven-pointterminalblockisprovided
tofacilitatewiring.Terminalblock
accommodateswiresizerangingfrom
26-10AWG.
Mounting Hood and Globe Gaskets
Siliconerubbergasketssealoutmoisture,dirt
anddust.Staysflexible,withstandsextreme
temperatures.Closuredesignassuresuniform
gasketcompression.
Epoxy Finish
Fixturehousing,hoodsandguardsare
copperfreealuminumwithtripleprotection
epoxypowdercoatfinish.
Stainless Steel Latch
Assembly
Captive,stainlesssteel
latchassemblyboltand
nutclosessecurely,
resistsattackof
corrosiveatmospheres.
Swing-awaydesign
simplifiesservicing.
Prismatic
Refractors
Heat-resistant
refractorthreads
directlyintofixture
housingandseal
againstahigh-
temperaturesilicone
rubbergasket.
Electrical Protection
Groundwireprovidedtobondmounting
hoodtofixturehousing.External
Groundingprovisionforadditionalsafety.
Reflectors and Visors
Reflectorsarethick,
toughfiberglass
reinforcedwhite
polyester.Visor
isaluminumwith
electrostatically
applied,grayepoxy
powdercoatfinish.
Quicklyattacheither
accessorytoluminaire
withfurnished
stainlesssteelscrews.
“Safety” High Hinge
Extra-highhinge
providesadditional
protectionagainst
accidentalfixture
housingdisengagement
duringinstallationor
maintenance.
“Safety” Cable
Safetycableoption
threadsthroughthe
fixturehousingfor
additionalsafety.
 Factory Installed. Fusing only permitted for cCSAus rating.
 Available for 120-277 VAC models only.
 Use of fuse voids Marine Outside Type (Salt Water) rating.
LED/AREA: NEC/CEC, ATEX/IECEx ENCLOSED AND GASKETED
Visit our website at www.emerson.com or contact us at [phone].
© March 2019
2