Specifications

Chapter 2 Setting Up and Managing Address Book Server 15
Enabling Administration of Address Book Server
You must turn on Address Book Server before you can use Server Admin to congure
or enable it. This allows Server Admin to start, stop, and change settings for Address
Book Server.
To enable Address Book Server for administration:
1 Open Server Admin.
2 Select a server, click the Settings button in the toolbar, and then click the Services tab.
3 Select the checkbox for Address Book Server.
You can now congure and control Address Book Server using Server Admin.
Starting or Stopping Address Book Server
To start or stop Address Book Server:
1 Open Server Admin.
2 Select a server, then click the service disclosure triangle to show the services for
administration. These instructions assume Address Book Server has been enabled in
the service administration list of Server Admin. If not, see “Enabling Administration of
Address Book Server” on page 15 .
3 In the service list below the server, select Address Book.
4 Click Start Address Book, the service start button below the server list. If the service is
running, click Stop Address Book.
From the command line:
Start or stop Address Book Server using the serveradmin command.
To start Address Book Server: m
sudo serveradmin start addressbook
To stop Address Book Server: m
sudo serveradmin stop addressbook