System information

30 Chapter 3
Note: The World Wide Name is not the same as the World Wide Port Name (WWPN)
used for LUN masking. See “Masking Drives on Multiple Host Systems (LUN Masking)” on
page 21 for information about LUN masking and WWPN.
m Network displays the IP address and related network details for each RAID controller.
Removing a System From the Monitoring List
You can easily take a system off the monitoring list.
Note: Avoid removing a system from the list if you don’t know its IP address or password.
If you remove a system, you must supply that information to list it again.
m To remove a system from the monitoring list, select it in the list and click Remove System.
Changing System Settings
You can adjust most settings for the Xserve RAID system while the system is operating. In a
few instances, you must restart the system for a change to take effect.
Adjusting Basic Information and Network Settings
See “System Name and Contact Information” on page 10 for instructions on adjusting basic
system settings, including changing passwords for Administrator and Guest access.
See “Network Address” on page 11 for instructions on adjusting the network information.